Capsule FillerIntegrating machinery, electricity, and air, it uses a microcomputer programmable controller, touch screen operation, and variable frequency speed regulation. It is equipped with an electronic automatic counting device and can automatically complete actions such as capsule positioning, separation, filling, and locking, reducing labor intensity, improving production efficiency, and meeting medical and health requirements. The capsule filler is sensitive, the filling amount is accurate, and the operation is convenient. It is suitable for various domestic or imported capsule fillers. It is an economical and practical capsule drug filling equipment in the pharmaceutical industry.

　　Generally uses automatic intermittent rotary motion. The turntable installed in the center of the workbench rotates 8 times with a short dwell time. The turntable sends the capsules to each station around the turntable. During the short stop at each station, various operations are automatically performed simultaneously, such as capsule dispensing, capsule separation, filling, waste capsule removal, capsule locking, capsule extraction, and mold cleaning. Capsule filler operation steps: Press the green button in the "power switch" to power on the equipment. For the capsule filler, slowly adjust the "vibration intensity adjustment knob" by rotating it clockwise. At this time, the finished product plate integrated with the "vibration bracket" begins to vibrate. Touch the panel with your hand and adjust it to a certain vibration intensity according to your feeling.

　　Place the powder capsule shells into the "powder capsule shell sorting plate", about 300 at a time. Place the capsule caps into the "capsule cap fine decoration plate", about 300 at a time. The sorting plate uses an organic glass plate with many funnel-shaped round holes drilled in the top and bottom. The diameter of the round holes corresponds to the diameter of the capsule number. At this time, the vibrating pressure plate capsule shell moves smoothly and slowly back and forth, entering the pressure plate holes one by one. After about 30 seconds, the powder capsule shells and capsule caps fall into the round holes with the opening facing upwards. If there is one opening facing downwards, use the capsule cap to gently press down the sleeve and pull it out of the capsule filler, the horizontal handheld powder capsule shell connecting plate, gently push inward the lower part of the management plate, and the powder capsule shells in the sorting plate will fall into the round holes of the connecting plate, and then take out the connecting plate. Again, use the capsule cap connecting plate to remove the capsule caps.

　　You can prepare a powder square plate with a bottom area of 500 × and a height of 10mm and 500mm on four sides in advance, and place the powder capsule shell connecting plate flat in the powder square plate. Then cover the random organic glass frame on the powder capsule connecting plate, put the hopper powder into the frame, scrape it with the frame edge, fill it with powder, and scrape off the excess powder.Capsule FillerUse the randomly matched capsule cap fixing plate and place it on the capsule cap connecting plate with positioning holes for easy placement. Turn over the capsule cap connecting plate so that the capsule opening faces downwards, above the powder-filled capsule shell connecting plate. There are also alignment holes for easy insertion.

　　Place the sheathed capsule plate into the cavity under the "capsule cap template", and manually pull down the "pressure rod" into place. Because there is a positioning mechanism to control the compression height, excessive attention is not needed. Remove the sheathed capsule plate, pour out the capsules and fill them. You can cycle through the next circuit board.